PolyDryer – Filament Dryer & Storage System
Low stock
In stock, ready to ship
Description
Most bad prints are caused by wet filament. Stringing, bubbling, rough surfaces and weak layers usually come from moisture the spool absorbed while it sat on a shelf. During Kuwait's humid months, that happens faster than most people expect.
The PolyDryer was co-developed by Polymaker and FabNotion. It dries your filament, then keeps it dry, all in one unit.
How it works
The Dry Dock heats the sealed PolyDryer Box to a maximum of 70 °C. Air circulates 360° around the spool so it dries evenly, and the spool turns on a central holder while it dries. You can pick one of three preset power levels or run it continuously. Set the timer and walk away: the unit switches itself off when drying finishes, and it cuts power if the temperature gets too high.
When the filament is dry, lift the Box off the Dock and it works as sealed storage. The built-in hygrometer shows the humidity inside, and the desiccant compartment keeps it low until your next print.
Built to grow with you
One Dry Dock works with as many PolyDryer Boxes as you need. Add Boxes as your filament collection grows and dry each spool in turn. Polymaker also publishes printable add-ons on Printables, so you can adapt the system to your own setup.
Compatibility
- Materials: PLA, PETG, ABS, TPU, PA, PVA and more
- Filament diameter: 1.75 mm, 2.85 mm and 3.00 mm
- Spools: up to 1 kg, maximum 205 mm diameter × 78 mm width
Specifications
- Maximum temperature: 70 °C
- Modes: 3 preset power levels + continuous drying
- Power rating: 68 W
- Dimensions: 235 × 120 × 290 mm (Box on Dock)
- Safety: auto shut-off and over-temperature protection
In the box
- Dry Dock
- PolyDryer Box
- Hygrometer and desiccant box
- Filament seals
- Power adapter
Good to know
Drying only helps if the filament stays dry afterwards. Keep spools you aren't using sealed in a PolyDryer Box or an airtight container with desiccant. Nylon, TPU and PVA absorb moisture quickly, so dry them right before every print.